4 Channel Output RGBW 100W DMX 512 LED Driver 230V

Product descriptions

Thank you for using AC DMX512 Driver series.It adopts the advanced micro-computer control technology, it converts the DMX-512/1990 standard digital signal adopted widely in international to the analog control signal.Output 1~4 Channels for option and each channel able to achieve 256 levels of brightness controlling,and also it can be used as the connector of PC digital-light controller and analog light modulator. It is mainly used for the controlling of buildings & lights applied LED.

Details of DMX 512 LED Driver:

1,Meets DMX512/1990.

2,256-levels brightness,full-color with driver controls.

3,Power no explosive flash, high-frequency output, low jitter.

4,Output 4 channels,MAX 700mA per channel.

5,Can achieve asynchronous color changes effect under working with dmx master controller,dmx console or dmx switch .

6,Setting the DMX address freely.

7,Good resistance, humane terminal design.

8,Customized/3 Years Warranty 

Specification of DMX 512 LED Driver:

Images of DMX 512 LED Driver:

Instructions of DMX 512 LED Driver:

1,DMX signal input/output interface ( 3 PIN Screws Terminal ).

2,DMX address code set the switch interface (Using method see "DMX series address dial the meter")

3,LED Driver output interface (common anode drive with a 4-channel LED + interface and CH1-CH2-CH3-CH4-output interface, can connect all kinds of full-color module and monochrome module automatically according to the lamps module load adjust the output pulse).

Wiring Diagram:

DMX-512 control signal connection

1,DIP switch 1-9 bits are all pulling to the 0 position for each channel self-test function, LED full light again lit every channel order.

2,DMX signal cable with twisted pair UTP (network cable), DMX signal of positive and negative terminals, crimping DMX signal cable plug is paying particular attention to polarity. The DMX512 controller input and output terminals of the common three-mile, please correspond polarity connection.

3,DMX5000 output and  transmission lines can't be over 300 meters.

4, DMX5000 each interface can with not more than 128 pieces of DE8239H-4CH. Eight output interface. Through the JBLED FLASH light making software and can with computer on line control. Realize infinite connect the DMX lights.

5,When contacting 32 pieces of DE8239H-4CH, DMX signal must add a signal amplifier RE2000 . Cascade can't more than 4 PCS.

6, At the end of the connection, we should connect a DMX signal finalizer ( Put down the code switch no.10 of DE8239H-4CH dial).